legacycentral bbs

I'm a ghetto tinkerer so the conservative EGT's I run are my little buffer to try to keep the motor from going BOOM! BUT 1610* still sounds a bit high to me! 800*C is about 1472*F which is alot cooler than 1610*F. I contacted Revtronix & they said they can copy the stock EJ20G parameters (440cc...

Anyone? Could i possibly be the o2 sensor making the other two throw???

Ok so i reset my easy but i still am throwing these three codes. (24) Air control valve, (32) O2 sensor, (35) canister purge solenoid valve. I replaced the o2 one with a used one recently and it worked for awhile but now this one has gone bad to. Also the air control valve comes and goes randomly fo...

Where else is there oil on the engine besides around the filter? Also when where these seals replaced?

Also kartboy makes a good one. It's good to replace it but its easy to replace another time if you don't have the cash for it now.

Take the 22t one and built a bracket that extends it so its closer to the throttle body that's what i did. Just use some ones 110 welder.

WRX/STI dp will work dandy but why spend $125 which everyone seems to think they should charge for them and spend $150 for a Ebay 3in bellmouth dp. Also as he said the STI pump will be plenty but depending on how much your paying you might as well get a brand new walbro 255 fuel pump for about $100 ...

Also check the tension on your throttle cable because if that is just a little to tight it does that. But it is most likely the IAC which i have that issue with mine.

It's not shooting out a blue cloud when you get on it by any chance or when its just idling? Mmm if there's alot around the filter it could possibly be your oil pan gasket. Could also be the front or rear main seal and with those high mileage it is very likely these need to be replaced also it could...

Ok so hmmm it seems to be consistent and it always throws these three codes. They are (24) Air control valve, (32) O2 sensor, (35) canister purge solenoid valve. Any suggestions on what could be causing this? I did replace my o2 sensor with a used one awhile back and it went away for awhile... but n...

Hey so I'm having a problem i used to boost to 9psi on a 16g turbo. So i got a short that was blowing a fuse and i found the short and replaced the fuse and got the car running. But now when i got on boost it only makes it to 5psi and wont budge. I do have a MBC but i have not adjusted it before or ...

Yes they would fit on a 94 impreza, they were on my 93 imp and 95 imp at one point. The only thing you would need to get are the brackets to mount the sway bar on at a junk yard. Have your gf go with you and put them in her purse haha that's how i got mine. Just make sure its a purse she doesn't lik...

buuump

Also have everything you need to put AC in your car. The only thing i cant seem to find is the piece that goes under the dash. This is out of a 95 Subaru Impreza

i dont know theres been a new EJ22T block on craigslist which is also listed with a used EJ22T block if that helps any. heres the page.

http://portland.craigslist.org/wsc/pts/921380877.html

lol come on the brat is a great work truck! It also gets good gas mileage! haha

mmm man sooo tempting... think it would make it back to oregon?? haha any chance you might want a 79 brat???

Devan( livestrong something) has one hit him up.

could it possibly be your O2 sensor? because when my o2 wasn't getting enough flow and alot of back up from the cat that i was infront of it threw the o2, and the purge solenoid code.

You caught my attention I'm interested in this. How long until they get around to stage x? lol

I need a 91 legacy SS hydro clutch line that is on the tranny that goes from the slave to the flexible hose line(only need the hard line.) Let me know if you guys have it, Thanks

ok so i searched this thread but no one specifically said (well that i could find anyways) what you hook a FCD to i'm 99% sure its the map but i don't wanna wire it up to that then find out its sup post to be the maf. But as i said i'm 99% sure that its the map but i wanna make sure, thanks guys!

I need a:

Maf
Boost soleniod
Map
Legacy ss ECU
air intake assembly up to the resonator


Looking for this parts shipped to 97333 let me know thanks!

ok last call anyone interested? i might do this again in another few months or you can send me a pm and i can make you one but it will cost more. Thanks

buuuuuuumpity

bumpp