Page 1 of 1
Budget exhaust?
Posted: Fri Jun 24, 2011 12:59 am
by comets
I have a somewhat leaky exhaust on my 94 Wagon,
I probably won't go OEM'ish replacements.
What are your budget exhaust builds like?
I want something dual tipped yet stealth looking with a low rumble.
Stock cat / headers.
Re: Budget exhaust?
Posted: Fri Jun 24, 2011 5:45 pm
by Legacy777
Is this on a non-turbo or turbo car?
You're best bet is to have an exhaust shop weld something up for you.
Re: Budget exhaust?
Posted: Tue Jun 28, 2011 12:25 am
by comets
Is for my non-turbo Wagon.
Is there a muffler I should look for?
Re: Budget exhaust?
Posted: Tue Jun 28, 2011 5:55 pm
by Legacy777
If you have an exhaust shop weld something up, it's up to you on the muffler. There's a lot of different brands out there. Borla, flowmaster, magnaflow, etc all make a generic fit muffler. It depends if you want it to be loud or not. The non-turbo engines can produce a droning exhaust note on the highway without the installation of a resonator, so you may want to also look into that.
Re: Budget exhaust?
Posted: Wed Oct 26, 2011 9:22 pm
by SUBYLUV871
i got a magnaflow copy, made by them but they dont stamp it. $47 2 1/4 sound good too.
Re: Budget exhaust?
Posted: Sun Oct 30, 2011 10:12 pm
by Legacy777
Looks good!
Re: Budget exhaust?
Posted: Mon Oct 31, 2011 5:02 am
by SUBYLUV871
Thanks. With no tip on it it rumbled In The cab so bad. But ya I'm happy with my budget exhaust.
Re: Budget exhaust?
Posted: Mon Oct 31, 2011 6:39 am
by Falken-18c
i had a magnaflow mufler like subyluv871 on my stock exhaust it was loud except it was on it when i bought it but i have the same mufler brand new it cost me 130$ wish mine was only 47$
Re: Budget exhaust?
Posted: Tue Dec 06, 2011 6:26 pm
by Conrad1147
Where did you find the generic magnaflow muffler?
Re: Budget exhaust?
Posted: Tue Dec 06, 2011 7:29 pm
by SUBYLUV871
Re: Budget exhaust?
Posted: Fri Dec 16, 2011 3:21 am
by cal_look_zero
I have yet to acquire the funds to make it happen, but I'm doing a full exhaust to the tune of $400 and change pending on welding costs. Assuming I do the welding myself, I'll be under $400.
http://www.semotors.com/tsudo-97-05-sub ... -downpipe/
Ignore the DP part, it's a catted midpipe.
http://www.ebay.com/itm/Remus-Style-Res ... 041wt_1185
Going to polish the tips out so they're not gaudy rainbow color.
http://www.ebay.com/itm/JEGS-30610-2-5O ... 2141wt_952
8' of 2.5" tubing
http://www.ebay.com/itm/Summit-Racing-E ... 1444wt_952
J tube to cut up for bends.