ENGINE CUTOUT
Posted: Mon Jul 01, 2002 6:36 am
Just completed an engine conversion from a japanese wrx half cut
(1994 model-manual) into a legacy touring wagon (1992-auto). Every
thing seems to be working fine except the engine sometimes cuts
out/flat spot when in 2nd, 3rd or 4th gear when you drive with your
foot flat to the floor. It always seems to happen between 4500 &
5000 RPM's and then is fine again after 5000 RPM's. Ran a diognostics
on the car which came up with error code number 43 (which does not
seem to exist). If anyone has any ideas on what it might be I would
appreciate to hear as I am sick of almost going through the
windscreen everytime it happens.
regards L.M.
To unsubscribe from this group, please send an email to:
BC-BFLegacyWorks-unsubscribe@egroups.com
(1994 model-manual) into a legacy touring wagon (1992-auto). Every
thing seems to be working fine except the engine sometimes cuts
out/flat spot when in 2nd, 3rd or 4th gear when you drive with your
foot flat to the floor. It always seems to happen between 4500 &
5000 RPM's and then is fine again after 5000 RPM's. Ran a diognostics
on the car which came up with error code number 43 (which does not
seem to exist). If anyone has any ideas on what it might be I would
appreciate to hear as I am sick of almost going through the
windscreen everytime it happens.
regards L.M.
To unsubscribe from this group, please send an email to:
BC-BFLegacyWorks-unsubscribe@egroups.com