Page 1 of 1
Japanese Legacy Technical Information required
Posted: Fri Oct 25, 2002 4:55 pm
by rob neville
I need a detailed information on the following;
Engine type EJ20GDX1BE
Auto. Trans. type TZ102ZB1AA
Wiring loom of Legacy model BF5B49P.
I purchased the "front cut" of this car but cannot find any workshop manuals that cover it.
Can anyone give me a lead?
Rob
Japanese Legacy Technical Information required
Posted: Fri Oct 25, 2002 10:05 pm
by Mark Ward_
I have some of the information on my legacy page and Dave has a tonne as well.
www.rrunracing.com and go to the legacy link.
Mark
Japanese Legacy Technical Information required
Posted: Fri Nov 01, 2002 2:55 am
by rob neville
Thanks Mark for the reply.
I have checked the site & have found a little more information.
The colour coding in the wiring diagram does match mine, it seems to be from a later model.
The reason I need information is that I am using the engine in a sports car that I am building, (my own design), this car will be rear engined & of course rear wheel drive. I am not sure whether to use the original 4EAT (modified) or the 4WD trans. (modified). The auto may be better from the wiring loom aspect, but it is bulky & heavy. A workshop manual or extracts from it would make my task a lot easier. The Legacy has only travelled 33000 kilometres, so the engine & trans. should be in good condition.
Any advise is appreciated.
Regards
Rob
Japanese Legacy Technical Information required
Posted: Fri Nov 01, 2002 2:55 am
by Marc
do send photos! Home made cars rule.