Page 1 of 1

My next Mod: 4eat FWD -> 5mt AWD

Posted: Wed Nov 12, 2003 4:57 am
by mTk
This has been a great year for my car, my dreams for it have progressed farther than i had imagined.

This year i swapped in an ej22t, now i am about to do the lovely 5mt AWD swap.

The reason for the changeover is that my stock fwd 4eat decided it couldn't handle the power of my new engine and crapped it's pants.

Looks like so far i've sourced the tranny, clutch, flywheel, axles and driveshafts

I still need the rear crossmember, gas tank, shift linkage, clutch reservoir, slave cylinder, and hubs.

It should be pretty straight forward, though i'm sure i'll have a few questions for the board :)

MK

Posted: Wed Nov 12, 2003 5:04 am
by vrg3
I believe I have a full set of Legacy Turbo clutch hydraulics (master cylinder/reservoir, damper, slave cylinder, and hoses) around here somewhere... PM me if you're interested.

Posted: Wed Nov 12, 2003 6:53 pm
by HomeSlice
ill be on that road very soon too.
good luck with the icing on the cake.
Cheers,
Jim

Posted: Thu Nov 20, 2003 10:58 am
by mTk
Small update:

Here's what i have/know exactly where i am getting from:
-Legacy turbo 5mt
-Legacy turbo rear dif
-Flywheel
-clutch w/ pedals and hydraulics

-AWD fuel tank w/ straps and filler neck
-AWD rear hubs-axles
-Turbo rear brakes
-AWD rear crossmember


MK

Posted: Thu Nov 20, 2003 2:43 pm
by vrg3
You should ask ciper if he still has the turbo rear brakes for sale. The other parts you can find cheaply in a junkyard.

Posted: Sat Nov 22, 2003 9:25 pm
by mTk
mTk wrote: -AWD fuel tank w/ straps and filler neck
-AWD rear hubs-axles
-Turbo rear brakes :D
-AWD rear crossmember
MK
For shift linkage i may be going to go with the STi assembly.

MK

Posted: Sat Dec 06, 2003 5:51 am
by mTk
Update

I will be using the WRX shift linkage

Almost every part is on it's way now, the only thing i still need is the the first section of the center driveshaft.

MK