trans swap
Posted: Sat Dec 13, 2003 9:59 am
can anyone confirm whether a auto trans from a EJ20GD bolt on to a EJ20ED, from all i've read so far, it looks as if it will
legacycentral bbs
A forum for 89-94 BC-BF(BJ) Legacy Owners and Fans
https://bbs.legacycentral.org/
trans swap
Page 1 of 1
Posted: Sat Dec 13, 2003 4:56 pm
I doubt it wont work, legos baby
Posted: Sat Dec 13, 2003 6:02 pm
Instead of engine codes can you post the model and year?
Posted: Sat Dec 13, 2003 7:44 pm
too...many...negatives....THAWA wrote:I doubt it wont work, legos baby
Posted: Sat Dec 13, 2003 10:01 pm
....huhTHAWA wrote:I doubt it wont work, legos baby
ciper Posted: Sat Dec 13, 2003 10:02 am Post subject:
--------------------------------------------------------------------------------
Instead of engine codes can you post the model and year?
EJ20GD is in '89 GT Legacy with TZ102ZB1AA auto trans,
EJ20ED is in '91 Brighton with a TZ102ZS2AA auto trans
Posted: Sat Dec 13, 2003 10:28 pm
I think it will work. ej series = legoscruznz wrote:....huhTHAWA wrote:I doubt it wont work, legos baby
Posted: Sat Dec 13, 2003 10:29 pm
only onescottzg wrote:too...many...negatives....THAWA wrote:I doubt it wont work, legos baby
Posted: Sat Dec 13, 2003 10:37 pm
I think it may work too,....but wanted to see if anyone may have done this change or have a bit more info than what i've managed to find.THAWA wrote:I think it will work. ej series = legoscruznz wrote:....huhTHAWA wrote:I doubt it wont work, legos baby
After deciphering the tranny codes,the only difference i've found is, 1 is for DOHC the other for SOHC, and seeing as the blocks are the same, i'm assuming that they will bolt up with no problem,...but we all know what they say about assumption...lol
Posted: Sun Dec 14, 2003 12:55 am
Ummm.... killed the cat?cruznz wrote:...but we all know what they say about assumption...lol
Posted: Sun Dec 14, 2003 3:43 am
Brat4by4 wrote:Ummm.... killed the cat?cruznz wrote:...but we all know what they say about assumption...lol
......had to be there i s'pose.....
Posted: Sun Dec 14, 2003 7:01 am
laughing for 5 minutes.Brat4by4 wrote:Ummm.... killed the cat?cruznz wrote:...but we all know what they say about assumption...lol
Posted: Sun Dec 14, 2003 7:16 pm
cruznz: Id say with much confidence that it will. Ive never heard of any EJ series transmission not bolting up. Clutch differences, driveshaft lengths and transmsision tube space is another story.
Posted: Sun Dec 14, 2003 9:50 pm
Thanks for your reply ciper,.....as for the differences you mention, i will check these all out before i attempt to put it in... 