Page 1 of 1
Ventilator Problem
Posted: Sat Aug 09, 2003 9:28 pm
by morgie
New problem appeared today. My ventilator / AC / heater ... inside .... doesn't work at position 4 (max). it works at 1 - 2 - 3, but at 4, it stops, no air blowing.. :\
what can this be?
thanks!
Posted: Sun Aug 10, 2003 4:26 am
by ciper
Isnt the fourth setting where the resistor is basically bypassed to allow full voltage to the fan? Id check the resistor unit first for continuity.
Posted: Sun Aug 10, 2003 6:28 am
by morgie
humm... ok... where is that ? haha
i'll go at my dealership to print the pages of the shop manual talking about that
Posted: Sun Aug 10, 2003 2:30 pm
by magicmike
yeah what ciper said. I'd be willing to bet there is a problem with the switch not the resistor pack.
Mike
Posted: Sun Aug 10, 2003 3:56 pm
by HomeSlice
i got a gauge set for sale if it is the switch
Posted: Mon Aug 11, 2003 2:29 pm
by Brat4by4
The resistor dealio is behind the glove box I do believe. I've lost 1 and 2 on my Brat. I'll have to go replace that thing one day.
Posted: Mon Aug 11, 2003 2:32 pm
by Legacy777
if it's the resistor pack it's usually the other way around 1,2,3 don't work while 4 does. You can try unplugging the resistor pack. If you still don't get anything for four, you can probably assume it's electrical and switch related.