Page 1 of 1
?? early legacy motor mount brackets needed ??
Posted: Thu May 25, 2006 5:48 am
by baccaruda
I'm putting new motor mounts on my project Legacy engine.
It had the round liquid-cushioned type.
I bought new solid rectangular style mounts.
the brackets are different!
Anybody have a pair of brackets for me?
Posted: Thu May 25, 2006 5:56 am
by nicfunkadelic
different = better
They fit, use them.
Nick
Posted: Fri May 26, 2006 5:21 pm
by PRT
I think it happened to me 6 year ago. Just take a die grinder and cut it.
Posted: Fri May 26, 2006 10:00 pm
by Threshld1
my brackets were different between the round mounts and the new group n ones also. I had no problem putting them on, no cutting involved.
Pics if it helps
Posted: Sat May 27, 2006 12:12 am
by PRT
Like I said, it was long ago... Looking at your pics, it might have been the heat shields that I trimmed to fit. All I remember was cutting was involved !!
Posted: Sat May 27, 2006 3:18 am
by Threshld1
it could have been, i had removed them cause they were rusted lose and rattled like no tomorrow. though i put a set on a co-workers 92L no problem either. so i dunno there might be a difference *shrugs*