Page 1 of 1
knock senser
Posted: Tue Nov 07, 2006 6:19 pm
by GotSubie
Hey I’m trying to diagnose a fuel cut problem so took off my intake manifold just to check to make sure everything was hooked up ok. Well I was looking at the knock sensor and I noticed the connecter looks a little messed up. So my question is what should I do because Subaru doesn’t sell those connecters separately and I’m no wiring genius.
Posted: Wed Nov 08, 2006 2:27 am
by Legacy777
The connector on the knock sensor side, or the connector on the chassis side?
Posted: Wed Nov 08, 2006 2:48 am
by GotSubie
the chassis side
Posted: Wed Nov 08, 2006 2:54 am
by Legacy777
Hmm.....not sure what to say about that.
Posted: Wed Nov 08, 2006 5:04 am
by Imprezive
Cut off both male and female parts of the connector and solder in a new spade connector.
Posted: Wed Nov 08, 2006 5:08 am
by Legacy777
There is shielding in the stock cable.
Posted: Wed Nov 08, 2006 5:19 am
by Imprezive
But you are only taking out the connector, shouldnt you be able to bridge the shielding with some other wire?
Posted: Sun Nov 26, 2006 4:54 am
by GotSubie
just to let you guys know. I cut off the ecu side connecter and took it down to ralli tech and the guy there kelly just re pinned it and i sulderd it back on. idk if its gonna fix my boosting problem yet but well see.