Page 1 of 1
Timing belt cover
Posted: Tue Nov 28, 2006 8:57 pm
by Tleg93
Question:
Is the plastic timing belt cover/gasket on a 91 turbo the same as one on an NA?
Another thing, what tool do you need to remove/install the oil pressure sensor?
Posted: Wed Nov 29, 2006 1:31 pm
by Tleg93
Can't anybody answer my questions? I never get any replies....
Posted: Wed Nov 29, 2006 7:53 pm
by 93forestpearl
The covers are the same (there's five pieces), except that the turbo motor have "TURBO" molded in underneath "SUBARU". Other than that, they are the same and are interchangable.
Re: Timing belt cover
Posted: Fri Dec 01, 2006 12:59 am
by Legacy777
Tleg93 wrote:Another thing, what tool do you need to remove/install the oil pressure sensor?
A wrench....it's pretty standard.
Posted: Sat Dec 09, 2006 7:54 am
by Blackbart
93forestpearl wrote:The covers are the same (there's five pieces), except that the turbo motor have "TURBO" molded in underneath "SUBARU". Other than that, they are the same and are interchangable.
The center covers are not interchangable. The n/a and turbo take different water pumps, the center timing covers allow for the difference in the watr pumps, the turbo mounts the thermostat on the front, the n/a mounts it facing down.. The other four pieces are interchangable.