Page 1 of 1
No boost when cel comes on
Posted: Sat Oct 20, 2007 9:17 pm
by Ej22TIM
I just replaced the boost control soleniod or whatever the red dealy is in front of the passenger side shock tower. the code is for boost control. i replaced the sensor along with all the other sensors on that panel (plugged in the whole set from a buddys t-leg) and my cel still pops.
it will hit fuel cut a 1 psi or as soon as it starts to boost. im running a MBC and i have a brand new o2 sensor.
can anyone help me?!
thanks,
Tim
Posted: Sun Oct 21, 2007 8:01 am
by Tleg93
Take your intake tract apart and find the vaccum hose that is disconnected. The only other things I can think of is that you have the hoses switched or the one that comes off from the throttle body isn't hooked up. It's a vaccum hose issue. See Vikash's vaccum hose sticky...
Posted: Sun Oct 21, 2007 2:48 pm
by dropdfocus
Good call Scott. Definitely check out the sticky post for the vacuum lines and also dive into the Stuff You Need Know section of the forum.
Posted: Sun Oct 21, 2007 9:16 pm
by Ej22TIM
do you have a link to that sticky? thanks for the help thats where i will start and i will let you know as soon as i figure it out.
cheers
Tim
Posted: Mon Oct 22, 2007 2:34 am
by dropdfocus
Go to the Intake section of the forum. It is at the top of the page.