Page 1 of 1
tps replacement
Posted: Fri Dec 28, 2007 11:52 pm
by dirtyhandssubaru555
so i got a good tps on the way, i was told not to mess with takeing the tps off unless you know what u are doing, but it doenst look that difficult. two screws, mark the srcews and the old tps and match up with mark with the new tps. yes or no?
Posted: Fri Dec 28, 2007 11:57 pm
by vrg3
You can't go by the marks necessarily. You need to calibrate the idle switch when you install the new TPS. Josh has posted a few times on how to do that.
Posted: Sat Dec 29, 2007 4:54 am
by dirtyhandssubaru555
vikash are are you stocking me? lol! i did a search and didnt see much. josh?
Posted: Sat Dec 29, 2007 5:19 am
by vrg3
Posted: Sun Dec 30, 2007 9:00 pm
by dirtyhandssubaru555
so if i don't get any reading from pins one and two on the tps, does that meen its totaly craped out? when i unplug it the car runs just the same. i didn't do any more testing cause i was being lazy last night and didnt want to start a fire in my garage
Posted: Wed Jan 02, 2008 4:42 pm
by Legacy777
Do you get continuity when you move the throttle?
Are you sure you're orienting the TPS correctly, and using the correct pins?
Posted: Wed Jan 02, 2008 11:34 pm
by dirtyhandssubaru555
i get nothing at all from pins 1 and 2, thats what my hanes has to start with.
Posted: Thu Jan 03, 2008 7:11 pm
by Legacy777
Did you look at the posts and links in the posts above to see if the info in there matches to Haynes?