Page 1 of 1
Fuel Controller wire ID.
Posted: Sun May 31, 2009 1:52 am
by Skruyd
Mmk, got the HKS Super AFR and just wanted to make sure the wire's I'm hooking up to are the right ones. Measure twice cut once
or in this case connect the right wire and don't fry the ECU
12v ignition = c10
ground = c11
TPS signal = b2
Air flow signal = a10
RPM signal = c16
And these are the pin outs from the ecu side
Thank you everyone.
Posted: Sun May 31, 2009 4:27 am
by Legacy777
I've fixed the air flow, 12v ign. and ground pins, and just for clarification, I'm going to put the actual ECU connector instead of the abbreviation from the factory book.
12v ignition = B48 pin 2
ground = F47 pin 14
TPS signal = B58 pin 2
Air flow signal = B48 pin 9
RPM signal = B56 pin 16
Where did you get the pin information above?
Posted: Sun May 31, 2009 9:35 am
by Skruyd
Legacy777 wrote:
Where did you get the pin information above?
Thanks for the info
. I got my info from 1991 Service Manual Section 6 pg. 12 Fig. 15.
Posted: Sun May 31, 2009 2:51 pm
by Legacy777
section 6-3?
Posted: Sun May 31, 2009 8:41 pm
by Skruyd
Nope, it 6-2. I was using the schematic and taking a stab at it. It didn't give much info on which wire did what. Just showed what connected to which part. I think I should have looked into book 2?
Posted: Mon Jun 01, 2009 1:46 am
by Legacy777
Yeah, should have used book 2.
Posted: Mon Jun 01, 2009 3:47 am
by n2x4
Legacy777 wrote:Yeah, should have used book 2.
Screw book 2, just ask Josh
Posted: Mon Jun 01, 2009 4:23 am
by Skruyd
n2x4 wrote:Legacy777 wrote:Yeah, should have used book 2.
Screw book 2, just ask Josh
I kind of did that, but didn't really want to because I had the info. Just didn't want to be stupid about it.