Page 1 of 1
EJ22t hoisting points?
Posted: Thu Oct 08, 2009 8:15 am
by WagonMafia
What are the best hoist points on a MY EJ22t motor? should i take the trans with it? i plan to swap with an n/a motor but keep the 4eat in the car.
Posted: Thu Oct 08, 2009 9:15 am
by BSOD2600
I've hooked into that loop in the rear of the engine -- sort of where the turbo intake pipe ends. Then screwed another bolt into the A/C brace/tower thing.
Posted: Thu Oct 08, 2009 9:59 am
by tturnpaw
I second that. Many of time that way with an engine leveler
Posted: Thu Oct 08, 2009 12:26 pm
by kimokalihi
Definately get an engine leveler. That thing is great. It allowed me to drop my engine in with the transmission attached all by myself. I even left the shift linkage and shifter on which made the tranny even longer.
Posted: Thu Oct 08, 2009 6:14 pm
by Legacy777
Yeah.....get the leveler.....I should of bought one....but I didn't.....would have made things much easier.
Posted: Thu Oct 08, 2009 6:28 pm
by SLODRIVE
I have an engine leveler here, but to be honest I prefer to pull/install Subie motors without it. They're so light it's really easy to shift the motor on the chain. The problem with the leveler is that you have to jack the hoist that much higher up to get the engine out of the car. As posted above, I normally hook a chain to the loop near the turbo and pull it through the loop on the A/C bracket.
That said...if I was pulling the tranny at the same time, or pulling a V-8, the leveler is the only way to go.
Posted: Fri Oct 09, 2009 5:04 am
by AWD_addict
I recommend an engine leveler. I've only used mine about 5 times, and I'm glad I bought it.
Posted: Sun Oct 11, 2009 5:07 pm
by WagonMafia
oh ya, definatly using the leveler. its as god sent when working with 4g63s because of the pass side mount. male side of the mount has to 1st dip under the fender female mount then the rest of the motor can slide in to place and finally line both mounts up and slide your bolts in. then try doing that with this thing...
http://www.cardomain.com/ride/2705191 i think the motor came out 5 or 6 times throughout the process... FUN!!! now that the CRX is gone, the EK's getting an H22 swap.
http://www.cardomain.com/ride/3385690 Another BIG motor going into a small bay.
Posted: Sun Oct 11, 2009 8:34 pm
by tturnpaw
dont come here and speak that mitsu crap! lol
Posted: Mon Oct 12, 2009 4:17 pm
by cj91legss
i usually run a strap under the intake runers and it works pretty good.