Page 1 of 1
mating surfaces/ engine block?
Posted: Fri Dec 11, 2009 1:01 pm
by race_to_live
I know I saw someone talking about putting their block together and asking questions about adhesives and such. can someone send me in the right direction. If not, what do I use when putting the two halfs together? Or do I use anything?
EDIT: I don't have the torque specs or sequence for the block. I only have them for the heads. Can I get a link please. THANKS
Posted: Fri Dec 11, 2009 6:03 pm
by kleinkid
Check this out. Subaru manual says to use Three Bond 1215
http://www.main.experiencetherave.com/s ... alants.gif
Posted: Sat Dec 12, 2009 8:13 am
by 206er
google yamabond
its a yamaha product for applications like this and it is bad ass. just don't get it on your hands.
Posted: Sat Dec 12, 2009 8:58 am
by 93forestpearl
I've used Permatex Ultra Grey a few times without issue.
Posted: Mon Dec 14, 2009 6:52 am
by race_to_live
bump
bump?
Posted: Mon Dec 14, 2009 7:25 am
by kleinkid
Your question has been answered. Subaru says to use Threebond 1215 sealant for the block halves. Locktite and 3M both have equivalants listed in the chart.
Posted: Mon Dec 14, 2009 9:11 am
by race_to_live
My bad I should have said that I edited the post. I need the torque specs for putting the block together.
Posted: Mon Dec 14, 2009 4:39 pm
by 93forestpearl
http://bbs.legacycentral.org/viewtopic.php?t=14485
Go to this page, download the service manual, and go to page 88.
Posted: Mon Dec 14, 2009 5:40 pm
by kleinkid
Oops, I didn't notice you had edited for more info.
Dan's reference will have it for you.
