legacycentral bbs

looking to replace the stock clutch/flywheel setup.

looking for something that'll handle 300hp/300tq.

thanks in advance.

yat

try this. its only a stock replacement clutch but would probably be ok at 300 hp if you're nice to it.

http://cgi.ebay.com/ebaymotors/EXEDY-CL ... 2506wt_907

I went with the exedy lightweight flywheel and a stage one clutch that was meant for a WRX. Everything went together like legos. I did remove the metal cover on the underside of the engine that covers the bottom of the flywheel, as the clearance was bit close. I love the combo as well.

thanks for the reply. i haven't installed it yet but i went with the ACT street clutch kit with a streetlite flywheel.

im lookin for the same thing. in your car turbo?

It would have to be a turbo car - Only the turbo transmissions would accept a WRX clutch.

jeffrhomola33 wrote:im lookin for the same thing. in your car turbo?

yes, my car is a 91 legacy turbo. it is installed but i have yet to pick up the car.

I have the ACT street disk as well, with a factory pressure plate and flywheel. No issues, it grabs hard and puts up with my abuse.