legacycentral bbs

So I just got done with my rob tune vf39 and fmic. I have a code 45 I changed both the solenoid and the sensor and the code is still there. Driving the car once I get to about 4k it falls on its face and stumbles, sometimes the motor will die too. Also at idle the motor dies everonce in a while but it doesn't stumble or anything it just seems like the powere gets cut.

Hi,
You did this, correct?:

Wiring
The ignition differences are described above, but the MAP sensor also needs addressed. Otherwise, it'll throw a code - 45. The solution is to remove pin 5 on B48 and join it with pin 21 on B48 @ the ECU connector.

It's part of the swap when using the EJ20G ECU.

GL,
Td