legacycentral bbs

Hey, so i've taken apart my engine a bit and the inevitable happened... i broke something.

The nipple attached to the 90 bend is being held on by like 1cm of rubber (it ripped). It's the one that goes to the bpv.


Since I'm doing the coffee cup (and mbc) can i just put all the nipples on one coffee cup and then 90 down to the turbo inlet? like so.... (excuse the bad "Paint" job)


Thanks!

That's how mine looks to be setup

If you can fit it all on the coffee cup part, that's actually VERY ideal compared to having anything on the elbow, that way you're free from rare and expensive OEM elbows or even more rare and exorbitantly expensive Samco EJ20G elbows.

diesel devil sells the 90's thats where i gots mine

Okay, maybe not rare but they are still more expensive than a generic silicon 90.