Page 1 of 1
Car won't crank, code 35?
Posted: Sat Apr 20, 2013 5:29 pm
by Someperson
Going to have the starter tested cause the relay clicks but no crank
Re: Car won't crank, code 35?
Posted: Sat Apr 20, 2013 5:55 pm
by Someperson
Starters good
Re: Car won't crank, code 35?
Posted: Sun Apr 21, 2013 12:39 am
by FundamentalyConfused
The Haynes manual says code 35 is Purge control solenoid valve. Purge control solenoid remains in the ON or OFF position during operation. It also says refer to chapter 6 but that is read in chapter 6 and I can't find anything else on a purge control solenoid.
Re: Car won't crank, code 35?
Posted: Sun Apr 21, 2013 12:44 am
by sqc151
i know this sounds funny, but did you connect the black wire to the starter?
Re: Car won't crank, code 35?
Posted: Sun Apr 21, 2013 2:23 am
by Legacy777
Code 35 won't keep the car from starting. Sounds like you've got another issue.
Re: Car won't crank, code 35?
Posted: Sun Apr 21, 2013 4:44 pm
by Someperson
Green wire under the dash for the ignition was cut, gonna put a quick-disconnect for security porpoises