legacycentral bbs

Posted: **Sun May 19, 2013 8:35 pm**

I tore this out of my non turbo 94 Legacy in October of 2011. I overheated it at least 4/5 times myself.. I have no idea how many times it has been overheated before me. It had 173K at the time of pull.

I've finally got around to messing with it.

Here are the results of tearing into it. .. .

[WARNING]
It's a bit skankified.

Left side

Right side

Left head

Right head

Split block

Bit of marring inside the block.

Pistons cleaned up a bit.

Posted: **Mon May 20, 2013 12:03 am**

Those actually don't look too bad....

Posted: **Mon May 20, 2013 1:41 pm**

Really?! That's good! Should I take the block and heads to a machine shop to be tested??

Posted: **Mon May 20, 2013 5:30 pm**

If you're planning to rebuild it, yeah I would have them look it over. The heads will probably need a valve job and to be resurfaced. The deck on the block will likely need to be resurfaced as well.

legacycentral bbs

Started tearing into the boat anchor EJ22 (Large pictures)

Started tearing into the boat anchor EJ22 (Large pictures)

Re: Started tearing into the boat anchor EJ22 (Large pictur

Re: Started tearing into the boat anchor EJ22 (Large pictur

Re: Started tearing into the boat anchor EJ22 (Large pictur