Remote Start/Alarm advice
Posted: Wed Nov 20, 2013 11:20 pm
I'm going to be putting in an Avital 5303 Remote Start, Alarm, Keyless entry system into my 1991 Legacy Wagon tomorrow and have spent the past week researching the install to get a good feel for it all. I already know the locations of all the important basic wires that need to be installed to make the remote start and alarm function. I have come up with a few tricks to connect the neutral switch, clutch switch, and e-brake to the alarm system to make this system safe for a 5-spd car.
My issues are these:
I can't think of a good place to mount the module under the dash in which the module can be mounted solidly and won't interfere with pedal travel. Any tips?
And almost any function that is accomplished by the module is accomplished through the use of 200mA grounds that can only support the small current of relay. Due to this, I will have to mount about 5 SPDT relays under the dash as neatly as possible. Does anyone have any idea where to mount these?
And finally, how should I get power to all of these relays? Is there a large positive cable going to the fuse box that I can tap into (fused of course)? Or should I run another wire from the battery to the dash?
Any help is much appreciated,
Austin
My issues are these:
I can't think of a good place to mount the module under the dash in which the module can be mounted solidly and won't interfere with pedal travel. Any tips?
And almost any function that is accomplished by the module is accomplished through the use of 200mA grounds that can only support the small current of relay. Due to this, I will have to mount about 5 SPDT relays under the dash as neatly as possible. Does anyone have any idea where to mount these?
And finally, how should I get power to all of these relays? Is there a large positive cable going to the fuse box that I can tap into (fused of course)? Or should I run another wire from the battery to the dash?
Any help is much appreciated,
Austin