Trouble with trouble codes
Posted: Mon Aug 27, 2001 1:46 pm
I have a "Check Engine Light" on all the time.
This is what I was told on how to read the codes:
1 - disconnect test mode connector
2 - key up without running engine
3 - Check engine light should flash code by flashing sequence
I tried to do this. The check engine light did not flash. What am I
doing wrong?
Is the test mode connector normally connected or disconnected? Should
the read memory connector be
connected or disconnected?
Mark
90 Legacy 2.2L
------------------------ ---------------------~-->
FREE COLLEGE MONEY
CLICK HERE to search
600,000 scholarships!
http://us.click.yahoo.com/zoU8wD/4m7CAA ... /XoTolB/TM
---------------------------------------------------------------------~->
To unsubscribe from this group, please send an email to:
BC-BFLegacyWorks-unsubscribe@egroups.com
This is what I was told on how to read the codes:
1 - disconnect test mode connector
2 - key up without running engine
3 - Check engine light should flash code by flashing sequence
I tried to do this. The check engine light did not flash. What am I
doing wrong?
Is the test mode connector normally connected or disconnected? Should
the read memory connector be
connected or disconnected?
Mark
90 Legacy 2.2L
------------------------ ---------------------~-->
FREE COLLEGE MONEY
CLICK HERE to search
600,000 scholarships!
http://us.click.yahoo.com/zoU8wD/4m7CAA ... /XoTolB/TM
---------------------------------------------------------------------~->
To unsubscribe from this group, please send an email to:
BC-BFLegacyWorks-unsubscribe@egroups.com