Coolant line size...?

Heads, valves, pistons, rods, crankshaft, etc...

Moderators: Helpinators, Moderators

Post Reply
IronMonkeyL255
Fourth Gear
Posts: 1902
Joined: Sat Aug 09, 2003 5:02 pm
Location: Woodruff, SC

Coolant line size...?

Post by IronMonkeyL255 »

What size is the bottom-most coolant line on the stock coolant tank?

I was trying to flip it so I can install my intercooler, but the bottom hose can't twist enough without kinking.

I'm just going to go buy a longer hose and possibly a tee-fitting to make it work.
Disclaimer: If anything I post is inaccurate, please correct me. I do not wish to add to the misinformation floating around on the internet.

That being said, everything I post is accurate to the best of my knowledge.

Rio Red '91 Legacy SS
Top
vrg3
Vikash
Posts: 12517
Joined: Sun Nov 03, 2002 2:13 am
Location: USA, OH, Cleveland (sometimes visiting DC though)
Contact:
Contact vrg3

Post by vrg3 »

12mm, I think. 1/2" heater hose should fit.
"Just reading vrg3's convoluted, information-packed posts made me feel better all over again." -- subyluvr2212
Top
IronMonkeyL255
Fourth Gear
Posts: 1902
Joined: Sat Aug 09, 2003 5:02 pm
Location: Woodruff, SC

Post by IronMonkeyL255 »

thanks.
Disclaimer: If anything I post is inaccurate, please correct me. I do not wish to add to the misinformation floating around on the internet.

That being said, everything I post is accurate to the best of my knowledge.

Rio Red '91 Legacy SS
Top
Post Reply

Return to “Engine”