Perfect Power Map Database for Legacies.

[douglas vincent]

Email me your maps, and I can host them.

To get maps, right click and save. You must save these files directly into the SMT6 folder.

Blank working map. ie, it makes your car run like a stock ecu. Not completely true, but close.

http://www.vincentfurniture.com/photos/ ... asemap.SMT

Here are two maps of mine.


To get maps, right click and save.
http://www.vincentfurniture.com/photos/ ... timing.SMT



http://www.vincentfurniture.com/photos/ ... timing.SMT

[Legacy777]

right click and save as will allow you to save them.

I'm going to be wiring up my perfect power tonight, and will probably play with configuring everything, and setting the ranges. Once I get it all setup, and maps "zero'd" I'll see if I get the bucking that you & tyler got.

I also want to do some data logging

[douglas vincent]

My "better milage" map

Until I actually get my 12-1 rrfpr working right, I am stuck with 47 psi stock idle fuel pressure. gives me about 10-12 mpg. Uggghhh.....

So I did this map, back up to about 20 mpg.

http://www.vincentfurniture.com/photos/ ... milage.smt

[douglas vincent]

Here is a datalog of a 2nd and 3rd gear pull. Right click and save. It must be put in the SMT6 folder to be found.

http://www.vincentfurniture.com/photos/ ... MT6025.raw

[douglas vincent]

This is of interest because I am pushing 10 psi and have installed the plastic JEC MAF. If you have the Perfect Power program installed, you can load this 2nd, 3rd and 4rth gear pull and see that I max out at 4.59

http://www.vincentfurniture.com/photos/ ... MT6030.raw

[Legacy777]

Here's my blank map with the temp & AMP sensors calibrated for the stock turbo legacy MAP sensor. Temp should be the same for all the first gen legacies.

The temp's range goes from 100 to 205. The AMP's range goes from 1 bar absolute to 1.8 bar absolute.

The temp is close, but it may not be super accurate. I'm probably going to go back and redo it, but the calibrations are pretty close.

http://www.main.experiencetherave.com:8 ... hBlank.SMT

[Legacy777]

Here's a map of just the AMP calibration

http://www.main.experiencetherave.com:8 ... pcalib.smt