does anyone kn0w anybody who has a flow bench between corvallis and portland, remember i dont have a car right now haha. And is reasonably proced. because i am port and polishing my heads tomorrow and i will need them flowed soon.
Also do i even need to have them flowed? i just figure as long as i am pretty even on each runner and exhaust port i wouldnt have to have them flowed, or do you think it will make that big of a difference if they are not all exactly the same?
i am also gasket matching on the exhaust side.
anyone know who has a flow bench between corvallis-portland?
Moderators: Helpinators, Moderators
-
thehookeup
- Third Gear
- Posts: 619
- Joined: Wed Feb 22, 2006 5:14 am
- Location: portland OR
-
thehookeup
- Third Gear
- Posts: 619
- Joined: Wed Feb 22, 2006 5:14 am
- Location: portland OR