02 sensor info

[PJHARJ]

I just recieved an Autometer air/fuel ratio gauge and need to identify the
wires on the 02 sensor to install it. I have a 3-wire 02 with black, red
and white wires. anyone know which one I need to connect the gauge to? Does
anyone having a wiring digram for a '92 Turbo Legacy?

THanks,
PeteH

BTW, sorry to hear about your goodies getting ripped off Bill, I hope you
make out OK with your insurance........


To unsubscribe from this group, send an email to:
BC-BFLegacyWorks-unsubscribe@egroups.com

[chris trent]

black should be ground, red should be 12volt, white should be the
wire you want..check with a volt meter..


To unsubscribe from this group, send an email to:
BC-BFLegacyWorks-unsubscribe@egroups.com

[pjharj@sauk.com]

That is what I figured but didn't want to hook it up wrong because
the Autometer manual states :(Do not connect ohm meter to oxygen
sensor, or touch wire to ground or power. Damage to oxygen sensor
will result. If a volt meter is to be used, only use a high impedence
(10 mega ohm or higher) digital multimeter. Note: do not disconnect
wire to the computer.)

Has anyone installed this unit in a Sube?

TIA
Peteh

--- In BC-BFLegacyWorks@y..., "chris trent" <jimfoxjones@h...> wrote:
> black should be ground, red should be 12volt, white should be the
> wire you want..check with a volt meter..


To unsubscribe from this group, send an email to:
BC-BFLegacyWorks-unsubscribe@egroups.com