Manuel shifter assembly plate?

Tommio RS · Post by **Tommio RS** » Mon Sep 30, 2013 1:01 am

Hi there everyone!

I have a simple/maybe difficult question.

In a factory 5mt 1993 legacy SS the rubber shifter seal thing, does it have a metal ring/rectangle plate?

Because i removed the old auto shifter and it nicely bolts to the body with a rubber seal with the actual shifter assembly as this plate.

I would think this seal would get the same treatment for both MT and AT cars?

This NOT the shifter boot for a MT car!!!!

Thanks

Tom

wtdash · Post by **wtdash** » Mon Sep 30, 2013 4:27 am

RU referring to this part:

If so, RU stating the AT metal bracket doesn't fit on the 5-speed? I don't remember what I did on my swap.

Td

Tommio RS · Post by **Tommio RS** » Thu Oct 03, 2013 12:35 am

Well from what i have seen and worked with the 5mt should have a diff plate to hold the rubber seal.

The AT shifter is that plate/ total shifter assembly.

So i dunno. I think im going to go hit a wrecker and scope out some 5mt subi's!

Post by **Legacy777** » Wed Oct 09, 2013 5:18 am

Yes, there should be a separate metal plate that keeps the boot clamped to the body.

James614 · Post by **James614** » Thu Oct 10, 2013 12:12 am

Hmmm. I need this metal plate too, apparently. I though the rubber boot just screwed in there

Tommio RS · Post by **Tommio RS** » Mon Oct 28, 2013 2:59 am

Yes.

There is a MT shifter boot plate for any MT subaru!

I just went to my dealer and got me the correct one for my car!

Its probably the same boot plate for any MT car.

legacycentral bbs

A forum for 89-94 BC-BF(BJ) Legacy Owners and Fans

Manuel shifter assembly plate?

Manuel shifter assembly plate?

Re: Manuel shifter assembly plate?

Re: Manuel shifter assembly plate?

Re: Manuel shifter assembly plate?

Re: Manuel shifter assembly plate?

Re: Manuel shifter assembly plate?