Where does this crap go part 2...

magicmike · Post by **magicmike** » Mon Jul 05, 2004 9:11 pm

ok I'm STILL trying to get my engine install finished. I have um "found" two small hoses that are coming out of the transmission area. I do not remember disconnecting these from anything.......

any ideas?????

Post by **Legacy777** » Mon Jul 05, 2004 9:37 pm

they are more then likely vents of some sort.....but I may be wrong.

vrg3 · Post by **vrg3** » Mon Jul 05, 2004 9:39 pm

Is it possible that they're the ATF cooling lines? I don't know anything about the 4EAT.

magicmike · Post by **magicmike** » Mon Jul 05, 2004 9:49 pm

whats funny is that there are no marks on the ends like they were clamped. I thought they might be vents but ther were just pointing to the side or up I dont remember. I would think they would be pointing down if that was the case. But I'm lost....

oh yeah, defintely not cooling lines, they are already hooked up, these are smaller like vacume lines of some sort

QuickDrive · Post by **QuickDrive** » Mon Jul 05, 2004 10:42 pm

I'll go take a peek and see if I can follow those lines for you...

QuickDrive · Post by **QuickDrive** » Mon Jul 05, 2004 10:43 pm

Checked,

Like Josh said, must be a vent, mine goes no where too.

magicmike · Post by **magicmike** » Mon Jul 05, 2004 10:45 pm

awesome! thanks man, I can continue with the install, I've been sitting here waiting for a response lol

QuickDrive · Post by **QuickDrive** » Mon Jul 05, 2004 10:48 pm

Heheh, no problem

THAWA · Post by **THAWA** » Tue Jul 06, 2004 7:08 am

I too noticed that when I took out my tranny. I had never seen them before, and wondered where they went to. Good to know they were just vents.

WRXdan · Post by **WRXdan** » Tue Jul 06, 2004 5:30 pm

Yep, both are tranny vents that don't connect anywhere. One is a vent for the tranny pump the other (connected futher back) is the tranny main body vent.

THAWA · Post by **THAWA** » Tue Jul 06, 2004 5:32 pm

Apparently there was a recall for these vents/dipstick. If the car is driven too long at really cold temps or in real high humidity they will clog, and it will try to vent through the dipstick, certain ones wouldn't vent and end up blowing the rear seal where the driveshaft is. Least that's what I read.

legacycentral bbs

A forum for 89-94 BC-BF(BJ) Legacy Owners and Fans

Where does this crap go part 2...

Where does this crap go part 2...