legacycentral bbs

1) How much play do you have in the pedal? Maybe the clutch cable needs to be adjusted. if not... 2.) It's possible the pivot ball has pushed through the clutch fork.. if not... 3.) possible broken shift fork. I would figure on the first or second one. Thanks for that...I spoke to a mechanic today ...

BAC5.2 wrote:If the car is in 1st and you start it with the clutch pushed in, does the car move?

Will give it a go...but when I think about it, the car did not stall when I came to a stop in first gear with the clutch in???

gto7419 wrote:Are you sure your clutch is fully disengaging?

No. Could you tell me how I would check that it was?

Hi all, Yesterday I drove my 1990 legacy GX wagon (manual) with no problems. This morning I started her up (it was a cold morning maybe 5-6 degree celcius) it was fine. I drove down the road about a km or so and it started to get very hard to get the thing into gear. I stopped at some lights and cou...

SP-Boxer wrote:What is the offset? If it's 53, it doesn't matter that the tire is a 215/45/17 instead of a 215/40/17

I went and test fitted today. The offset is 55 and they DO NOT fit. The inside of the tyre rubs on the strut, JUST! Damn it I really wanted these!

bump...anyone done this?

Hi, I have lined up a deal for a set of:

2001 Legacy B4 (JDM) wheels with 215/45R17 tyres.

Will these rub on either the fender or the struts - I assume the wheels would be 17x7.5 but not sure of offset (if anyone knows width and offset for sure then that weould be helpful too.

Cheers

Hi, could anyone tell me what the spare wire and plug hanging from the harness that plugs into the MAF sensor is.

Mine is hanging in mid air and wondered where it should be...

Cheers.

Are you sure he replaced the parts? Yeah I made surwe to collect the old parts which I had marked previously. I'd try resetting the ECU yourself. Tried that :( Does the CEL come on, or do you have to pull the codes to see what comes up. Yip the CEL comes on when I start the engine from cold then as...

Hi there, I have a 1990 Legacy wagon 2.2 manual. I have been having trouble with rough idleing and engine check light errors. I have used a lot of info from this borad to check codes etc which enabled me to pull 35 and 24 from my ECU. I tried cleaning the IAC valve etc wth no luck so I eventually to...

Hi, that pic is not of my car (just the same wheel). Iassume the parts have just been painted.

No I haven't. Could you give a link? CHeers

Here's one I just found...same wheel as mine.

I will try and find one on the net else I will post a couple up later tonight or tomorrow. CHeers.

Just pulled all the trim around the steering column off and still NO F**KING screws.

Can anyone help me?

Thanks again. I have turned the wheel round and round and still can't see no damn screws????!!!! Might try removing the steering column covers again tonight.

Thanks, I have had a look for screws on the back of the wheel but found nothing Thanks for the info though...

I Have pulled prodded and unscrewed and I can't seem to get my damn steering wheel horn cover off. I have a 1990 Legacy GX wagan 2.2. How , oh how do I get the damn thing off - I can't find any caps with screws behind them or anything and with the amount of force I have already pulled with I am thin...